Installation

Instant Electric Hot Water Tap

1.Install the product and connect the water according to installation sketch.

2.Turn on the water source and switch the handle to both the "cold" and "hot" directions to let out water and check if there is any leakage at connections.

3.All electrical work must be installed by a licensed electrician. It must be installed to a doubled pole power point (GOP).

4. Switch the handle to the "hot" direction and the heating indicator light is on, showing that the product is heating. Five to 10 seconds later, hot water flows out. Switch the handle to the cold direction and the heating indicator light is off. The product stops heating and the heating indicator light is off.

5.If the product has electric leakage protector (you may choose to buy such accessory), please test if the protector works properly after the electric circuit is correctly connected. When the power is on, press the "reset" button and the power indicator light is on. Then press the "test" button and the indicator light is off after the "click" sound. This shows that the protector is functioning normally and the installation process is over.

Eco Instant Hot Water Mixer

RV Sliding Rail with Soap Dish